Advancedpunch Pro General Problems; Die Set End Of Life - Xerox Versant 80 Press User Manual

GBC AdvancedPunch Pro
Fault Code Cause
040-942 Punch chip container is full.
140-700 Punch chip container is near full.

AdvancedPunch Pro General Problems

Probable Cause
No power, will not punch
Punched holes are not aligned with the edge
of the paper
Sheets are jamming repeatedly at the die set
area.
Insert the Punch Chip Container message is
displayed on the User Display Panel (Advanced-
Punch Pro).

Die Set End of Life

If a die set is at the end of its life it will cause paper jams due to hanging paper chips.
This is a result of die plate wear and not pin wear (which cannot be corrected). When
this occurs, the die set must be replaced with a new one.
Note
Attempting to replace or sharpen pins will not correct the issue since the wear is in the
plates and therefore is not recommended.
22-24
Remedy
Empty punch container and then reinstall
it.
Empty punch container and then reinstall
it.
Remedy
1. Check that the power cord is attached
to back of punch unit and that it is
plugged into the wall.
2. If the problem continues, contact the
Customer Support Center.
• Follow instructions on die set labels to
properly configure the die for a specific
sheet size.
• Also, refer to Die Set Configuration
information and instructions.
• If the problem continues, contact the Cus-
tomer Support Center.
1. Remove the die set and inspect the die
throat for any stuck paper chads.
2. Remove the paper chads.
Ensure that the Punch Chip Container is fully
inserted.
If the problem continues, contact the Customer
Support Center.
Xerox
for more
® ®
Versant 80 Press
User Guide