Ohcf (Trays 8 And 9) Maintenance; Replacing The Bypass Tray Feed Rolls For The Ohcf (Trays 8 And 9) - Xerox Versant 80 Press User Manual

Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)

OHCF (Trays 8 and 9) Maintenance

Replacing the Bypass Tray Feed Rolls for the OHCF (Trays 8 and
9)
Tip
The feed rolls for OHCF bypass tray should be replaced when experiencing frequent
multifeeds, single feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the (OHCF) bypass tray feed rolls, which includes:
• Feed Roll
• Nudger Roll
• Retard Roll
Note
After you replace all of the feed rolls, contact your system administrator who will reset
the High Frequency Service Item (HFSI) usage counter for these CRU components to
zero (0).
1. Locate and access the Bypass Tray on top of the OHCF.
2. Lift up and open the Bypass Tray cover to access the feed roll components.
3. Remove and replace the feed roll by squeezing the metal shaft and lifting out.
® ®
Xerox Versant 80 Press 18-3
User Guide