Advancedpunch Pro Problem Solving; Fault Codes - Gbc Advancedpunch Pro - Xerox Versant 80 Press User Manual

2. Apply oil lightly along the length of the pad, but do not over saturate.
3. To oil the die set, apply a small bead of oil along the entire length of the felt strip
that is located on the die set.
Note
Do not use spray lubricants because they dry up quickly and leave a sticky residue.
4. Wipe clean, leaving a light coat of oil on them.
Oil from the die set may blemish the first few punched sheets after oil has been
applied.
5. Run punched test prints until the punched output is clean and free of oil.

AdvancedPunch Pro Problem Solving

Fault Codes - GBC AdvancedPunch Pro

Fault codes for the GBC AdvancedPunch Pro are displayed on the press User Interface
/ Control Panel.
Fault Code Cause
040-100 Jam is detected in the Advanced-
040-101 Punch Pro.
040-900
040-901
040-300 Front door of the Advanced-
Punch Pro is not closed.
040-940 The punch die set is missing or
not fully installed.
040-941 Punch chip container is missing
or not fully installed.
® ®
Xerox Versant 80 Press
User Guide
GBC AdvancedPunch Pro
Remedy
1. Open AdvancedPunch Pro front
door and look for a paper jam; refer
to Clearing Paper Jams in the Ad-
vancedPunch Pro.
2. Remove any paper jam.
3. Close front door.
Close front door of the AdvancedPunch Pro.
Install punch die set or fully insert it; close
front door.
Install and / or fully insert punch container;
close front door.
22-23