Replacing The Ohcf Feed Rolls For The Ohcf (Trays 8 And 9) - Xerox Versant 80 Press User Manual

Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)
4. Remove and replace the nudger roll using the same technique.
5. Remove and replace the retard roll using the same technique.
6. Close the bypass tray cover.
7. Verify that the tray is operating correctly by feeding paper from the bypass tray.
8. Either log in as the administrator or ask the administrator to perform the following
steps to reset the High Frequency Service Item (HFSI) count to zero (0):
a) At the Control Panel, press the Tools button.
b) From the screen that displays, select the Tools icon.
c) Select System Settings > Common Service Settings > Maintenance.
d) Use the up / down arrow buttons to access the next Maintenance screens.
e) Select the Technical Key Operator icon. The Technical Key Operator feature
displays.
f) Select the Multisheet Inserter (MSI / Bypass) rolls item that corresponds with
the newly-replaced components.
g) Select Reset Current Value. The system resets the High Frequency Service Item
(HFSI) to 0.
9. Exit the administrator mode by pressing the Log In / Out button on the Control Panel.
When prompted, select Logout.

Replacing the OHCF Feed Rolls for the OHCF (Trays 8 and 9)

The OHCF feed rolls should be replaced every 300,000 prints or when experiencing
frequent multifeeds, single feeds, or blank prints in the stack of the output prints.
18-4
® ®
Xerox Versant 80 Press
User Guide