Emptying The Hole Punch Waste Container - Xerox Versant 80 Press User Manual

Business Ready (BR) Finisher and Optional Booklet Maker
2. Grasp the booklet maker handle and pull the unit toward you until the staple cartridges
appear on the top edge of the device.
3. To remove the staple cartridge from the booklet maker, push down on the staple
cartridge handle as shown, then pull the cartridge out and up.
4. Turn the staple cartridge over.
5. To permit the staple cartridge handle to open out and away from the staple refill,
press in the green tabs, then pull back the handle.
6. To remove the staple refill, press the rear of the refill container as shown.
7. Replace the staple refill, then return the staple cartridge to the booklet maker.
8. Close the front door of the Business Ready Finisher.

Emptying the Hole Punch Waste Container

A message appears on the press User Interface (UI) when the hole punch waste container
is full.
Warning
Do not perform this procedure while the printer is copying or printing.
1. Open the front door of the Business Ready Finisher.
2. Remove the hole punch waste container from its slot near the top left of the finisher.
19-4
® ®
Xerox Versant 80 Press
User Guide