Messages On The User Display Panel; Settings On The User Display Panel - Xerox Versant 80 Press User Manual

Messages on the User Display Panel

Messages shown on the User Display Panel include the following:
Ready Bypass
When the Punch Mode is OFF, it is in the Bypass Mode. In this mode sheets are not
punched and simply feed through the punch unit to another inline finishing device.
Ready Single Punch
This indicates that the AdvancedPunch Pro is in the Single Punch Mode and is ready
to process a punch job; all sheets that run through the unit will be punched.
Running Bypass
This displays when the Bypass Mode is in operation.
Running Single Punch
This displays when the Single Punch Mode is in operation.
Chip Tray Full
This message displays when the Punch Chip Container is full of waste paper chips. The
container must be emptied.
Chip Tray Out
This message displays when the Punch Chip Container is removed or not fully inserted
into the punch unit.
Check Die
This message displays when the Die Set is removed or not fully inserted into the punch
unit. When this message displays, the punch unit will run in the Bypass Mode only.
Close Door
This message displays when the Front Door is open or not completely closed.
Paper Jam
This message displays when a sheet of paper becomes jammed within the punch unit;
refer to Clearing Paper Jams in the AdvancedPunch

Settings on the User Display Panel

The following settings are available on the AdvancedPunch Pro:
Punch Mode
There are two modes:
• Off (Bypass)
• Single Punch
® ®
Xerox Versant 80 Press
User Guide
GBC AdvancedPunch Pro
Pro.
22-5