Fault Codes - Standard Finisher Plus - Xerox Versant 80 Press User Manual

Fault code Possible cause
013-940 The Trimmer Waste Contain-
er is full or has a fault

Fault Codes - Standard Finisher Plus

Fault Code Possible Cause
013-108 to 013-110 The sensor or exit sensor in the
Finishing Transport did not
switch ON or did not switch OFF
within a specified amount of
time
013-910, 013-911 Paper jam at the transport
sensor or exit sensor (Finishing
Transport)
051-100 to 051-111, Paper jam
051-900
® ®
Xerox Versant 80 Press
User Guide
Press Problem Solving
Recommended solution
• Pull open the container and empty any
trimmer scraps from it.
• Reinsert the container into the module.
• Make sure the container is pushed in
completely.
• If fault persists, power off/on the press.
• If fault persists, call for service.
Recommended Solution
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
1. Check for any obstructions or
paper jams in the Finishing
Module and Finishing Transport
paper paths and clear them.
2. If necessary, power Off / On the
press and rescan or resend your
job.
3. If the fault persists, contact the
Customer Support Center.
14-33