Ohcf (Trays 8 And 9) Problem Solving; Fault Codes - Oversized High Capacity Feeder (Trays 8 And 9) - Xerox Versant 80 Press User Manual

Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)
e) Select the Technical Key Operator icon.
The Technical Key Operator feature displays.
f) Select the item (HCF) that corresponds with the newly-replaced components.
g) Select Reset Current Value. The system resets the High Frequency Service Item
(HFSI) to 0.
14. Exit administrator mode by pressing the Log In / Out button on the Control Panel.
When prompted, select Logout.

OHCF (Trays 8 and 9) Problem Solving

Fault Codes - Oversized High Capacity Feeder (Trays 8 and 9)

The OHCF fault codes below may pertain to a specific tray of the feeder. If you experience
these fault codes frequently, you should follow the procedure on how to replace the
feed rolls (Replacing the Bypass Tray Feed Rolls for the OHCF (Trays 8 and 9)
Replacing the OHCF Feed Rolls for the OHCF (Trays 8 and
Fault Area Fault Code
Bypass (Tray 178-120, 078-
5) 125, 078-126,
078-127
Tray 8 178-100, 178-
101
Trays 5 (By- 178-103
pass), 8, and
9
18-8
Possible Cause Recommended Solution
Repetitive misfeeds or
1. Fan the paper to eliminate pa-
multifeeds
2. Clean the Bypass Tray feed, re-
3. Replace feed rolls (feed, retard,
4.
Pre-registration sensor Perform the following in this order:
jam; during paper 1. Remove or clear any jammed
transportation, feed
sensor is not turned on
2.
within period of time
paper is transporting
3.
from tray
and
9)).
per adhesion (especially in high
humidity or high temperature
environments).
tard, and nudger rolls with a
damp cloth.
nudger); refer to Replacing the
Bypass Tray Feed Rolls for the
OHCF (Trays 8 and 9).
If problem persists, Call for ser-
vice.
paper.
Replace and fan the paper in
tray.
Replace the OHCF Feed Rolls;
refer to Replacing the OHCF
Feed Rolls for the OHCF (Trays
8 and 9).
® ®
Xerox Versant 80 Press
User Guide