Xerox Versant 80 Press User Manual page 247

Chained (Second) Oversized High Capacity Feeder (OHCF / Trays 8 and 9)
Fault Area Fault Code
Trays 8 and 9 078-125, 078-
126, 078-127,
178-106, 178-
156
Tray 8 178-112
Tray 9 178-113
Tray 9 178-150, 178-
151
® ®
Xerox Versant 80 Press
User Guide
Possible Cause Recommended Solution
Repetitive misfeeds or 1. Fan the paper to eliminate pa-
multifeeds
2. Check the position of Skew Ad-
3. Replace the tray feed rolls (feed,
4.
Gate sensor not Perform the following in this order:
turned on fault during 1. Remove or clear any jammed
paper transportation
from Tray 8
2.
3.
4. If problem still persists, contact
Gate sensor not Perform the following in this order:
turned on fault during 1. Remove or clear any jammed
paper transportation
from Tray 9
2. Replace and fan the paper in
3. Power Off / On the press.
4. If problem still persists, contact
Pre-registration or Perform the following in this order:
feed sensor jam dur- 1.
ing paper transporta-
tion from Tray 9
2.
3.
per adhesion (especially in high
humidity or high temperature
environments).
justment Levers. The levers
should be retracted.; refer to
Skew Adjustment Levers (Trays
8 and 9).
retard, nudger); refer to Repla-
cing the OHCF Feed Rolls for the
OHCF (Trays 8 and 9).
If problem persists, Call for ser-
vice.
paper.
Replace and fan the paper in
tray.
Power Off / On the press.
the Customer Support Center.
paper.
tray.
the Customer Support Center.
Remove or clear any jammed
paper.
Replace and fan the paper in
tray.
Replace the OHCF Feed Rolls;
refer to Replacing the OHCF
Feed Rolls for the OHCF (Trays
8 and 9).
18-9