Xerox Versant 80 Press User Manual page 228

1- or 2-Tray Oversized High Capacity Feeder (OHCF / Trays 6 and 7)
• Retard Roll
Note
After you replace all of the feed rolls, contact your system administrator who will reset
the HFSI usuage counter for these CRU components to zero (0).
1. Pull open the top tray of the OHCF to access the feed components.
2. Notice the feed roll compartment on the right side panel of the drawer.
3. Remove the nudger roll by pushing down on the black tab with one hand (which raises
the roll upward) and then squeezing the metal shaft on both ends with your other
hand. Lift out the nudger roll.
4. Replace the new roll by squeezing both ends of the metal shaft, and pushing down
on the black tab, insert and release the roll ends into the notches.
5. Next, remove the retard roll assembly at the side of the feeder tray to access the
retard roll. Unscrew the 3 thumbscrews.
6. Slide the retard assembly all the way to the left so it is out of the slots. Pull the
asssemly out towards you until completely removed from the tray. Set aside.
17-4
® ®
Xerox Versant 80 Press
User Guide