Xerox Versant 80 Press User Manual page 328

Standard Finisher / Booklet Maker Finisher
Fault code Possible cause
024-943 The booklet staple cartridge
is empty or stapling error oc-
curred
024-957 Post-Process Inserter Tray is
empty or out of paper
024-974 When feeding paper from the
Post-Process Inserter Tray, the
designated paper size and the
actual size of paper in the
tray differ.
024-976 Finisher staple fault
024-977 Finisher staple feeding is not
ready
024-978, 024-989 Booklet Maker Finisher staple
operation is not ready
024-979 The staple cartridge is empty
024-980 The stacker tay is full
024-981 The top tray is full
024-982 The Finisher stacker tray
lower safety warning is on
024-983 The Finisher Booklet tray is
full
024-984, 024-985 The Booklet stapler low staple
signal is on
024-987, 024-988 The Booklet folder tray is full
047-320 A communication error has
occurred with the Finisher
112-700 The Punch Waste Container
is full or near full
24-12
Recommended solution
Check the staple cartridge and reset cor-
rectly. If needed, replace with a new
cartridge. Resume job.
Add paper to the paper tray.
Reset/change the paper or cancel the job.
Check staples and reset correctly.
Check staples and reset correctly.
Check staples and reset correctly.
Check staples. Remove and replace the
staple cartridge.
Remove all paper from the stacker tray.
Remove all paper from the Finisher top
tray.
Remove all paper from the stacker tray
and remove any other obstructions.
Remove all paper from the Booklet tray.
Remove all paper from the Booklet tray.
Remove all paper fromthe tray. Set the
output tray for three-fold. Check that the
folder tray is correctly attached and set.
Power Off/On the press. Resend the print
job if needed. If fault persists, contact
Customer Support Center.
Remove and empty the waste container
and then reinstall it completely.
®
Xerox Versant
®
80 Press
User Guide