Fault Codes - Oversized High Capacity Feeder (Trays 8 And 9) - Xerox Versant 80 Press User Manual

Press Problem Solving
Fault Area Fault Code
Tray 6 078-102
Tray 7 078-156
Trays 6 and 7 078-2[00-
99], 078-
3[00-99],
078-4[00-
99], 078-
6[00-99],
078-9[00-
99]
Trays 6 and 7 078-106,
078-125,
078-126,
078-127,
078-156

Fault Codes - Oversized High Capacity Feeder (Trays 8 and 9)

The OHCF fault codes below may pertain to a specific tray of the feeder. If you experience
these fault codes frequently, you should follow the procedure on how to replace the
feed rolls (Replacing the Bypass Tray Feed Rolls for the OHCF (Trays 8 and 9)
Replacing the OHCF Feed Rolls for the OHCF (Trays 8 and
14-22
Possible Cause Recommended Solution
Regi sensor not turned on Perform the following in this order:
fault during paper trans- 1.
portation from Tray 6
2.
Regi sensor not turned on
fault during paper trans-
3.
portation from Tray 7
4.
General tray malfunction
Repetitive misfeeds or 1.
multifeeds
2. For 1-Tray OHCF (only):
3.
4.
5.
Remove or clear any
jammed paper.
Replace and fan the paper
in tray.
Power Off / On the press.
If problem still persists,
contact the Customer Sup-
port Center.
Fan the paper to eliminate
paper adhesion (especially
in high humidity or high
temperature environments).
Ensure that both Paper
Weight Switches are set
correctly; the switches are
located on paper tray.
Check the position of Skew
Adjustment Levers. The
levers should be retracted.;
refer to Skew Adjustment
Levers (Trays 6 and 7).
Replace the tray feed rolls
(feed, retard, nudger); refer
to Replacing the OHCF Feed
Rolls (Trays 6 and 7).
If problem still persists,
contact the Customer Sup-
port Center.
and
9)).
® ®
Xerox Versant 80 Press
User Guide