Adding Pins To A Die Set - Xerox Versant 80 Press User Manual

GBC AdvancedPunch Pro
b) Hold the Pressure Bar so that it is seats completely over the Dowel Pins.
c) Rotate the two Quarter Turn Fasteners clockwise until a click is felt to lock the
Pressure Bar in position.
Warning
To avoid damage to the die set and the AdvancedPunch Pro, ensure that the
Pressure Bar is attached and both Quarter Turn Fasteners are in the locked
position prior to inserting the die set into the AdvancedPunch Pro.

Adding Pins to a Die Set

Important
Before adding pins to any die set, always refer to the
Sizes and the Pin Removal Table for ISO Paper
are being added to the die set.
1. Rotate the two Quarter Turn Fasteners counter-clockwise to release the Pressure
Bar.
2. Remove the Pressure Bar and set aside.
3. Retrieve the pins from the pin storage tray inside the Front Door of the AdvancedPunch
Pro.
If the pins were stored in a different location, retrieve them now.
4. Add the appropriate pins to die set according to either the
Paper Sizes or the Pin Removal Table for ISO Paper
22-18
Pin Removal Table for US Paper
Sizes; this ensures that the correct pins
Pin Removal Table for US
Sizes.
®
Xerox
®
Versant 80 Press
User Guide