Changing The Die Stop Position - Xerox Versant 80 Press User Manual

When adding punch pins to a die set, ensure that the pins are completely seated
against the pin retainer prior to reattaching the pressure bar; refer to the following
table for examples of correct and incorrect seating of pins.
Correct Pin Seating
5. Replace the Pressure Bar by performing the following steps:
a) Line up the two Dowel Pin Holes with the exposed Dowel Pins.
b) Hold the Pressure Bar so that it is seats completely over the Dowel Pins.
c) Rotate the two Quarter Turn Fasteners clockwise until a click is felt to lock the
Pressure Bar in position.
Warning
To avoid damage to the die set and the AdvancedPunch Pro, ensure that the
Pressure Bar is attached and both Quarter Turn Fasteners are in the locked
position prior to inserting the die set into the AdvancedPunch Pro.

Changing the Die Stop Position

On some of the AdvancedPunch Pro die sets there is an adjustable die stop which is used
to change the hole position for the die set for certain sheet sizes.
For die sets with a die stop knob, the die stop must be set to the correct position or the
punched holes will not be centered on the sheet.
Common paper sizes are shown on the die stop handle label below the die stop knob.
For uncommon paper sizes, refer to
Stop Position Guide for ISO Paper
1. Choose one of the following:
® ®
Xerox Versant 80 Press
User Guide
Incorrect Pin Seating
Die Stop Position Guide for US Paper Sizes
Sizes.
GBC AdvancedPunch Pro
and Die
22-19