Xerox Versant 80 Press User Manual page 192

Press Problem Solving
Fault code Possible cause
012-100 to 012-104, Paper Jam along booklet
012-108 to 012-115, and/or folder paths
012-117 to 012-120
012-125, 012-132, The finisher malfunctioned
012-211 to 012-265,
012-282 to 012-296
012-302 Interlock Fail
012-400 Staple Waste Container near
full
012-949 Punch Waste Container is not
attached
024-931 The Staple Waste Container
is full or near full
024-932 The Staple Waste Container
is not attached
024-943 The booklet staple cartridge
is empty or stapling error oc-
curred
024-957 Post-Process Inserter Tray is
empty or out of paper
024-974 When feeding paper from the
Post-Process Inserter Tray, the
designated paper size and the
actual size of paper in the
tray differ.
024-976 Finisher staple fault
024-977 Finisher staple feeding is not
ready
024-978, 024-989 Booklet Maker Finisher staple
operation is not ready
024-979 The staple cartridge is empty
14-30
Recommended solution
Check for any paper jams in the paper
path and remove all sheets.
Check for any paper jams in the paper
path and remove all sheets. Power Off/On
the press and, if needed, resend the print
job. If fault persists, call for service.
Make sure the module door is fully closed.
Power Off / On the press if fault persists.
Remove and replace the staple waste
container in the finisher.
Check that the Punch Waste Container is
installed in the finisher and inserted cor-
rectly.
Remove the Staple Waste Container and
install a new one.
Check that the Staple Waste Container
is installed in the finisher and inserted
correctly.
Check the staple cartridge and reset cor-
rectly. If needed, replace with a new
cartridge. Resume job.
Add paper to the paper tray.
Reset/change the paper or cancel the job.
Check staples and reset correctly.
Check staples and reset correctly.
Check staples and reset correctly.
Check staples. Remove and replace the
staple cartridge.
®
Xerox Versant
®
80 Press
User Guide