Cisco D9865 Installation And Operation Manual page 134

Setting Up Dish Pointing,
Proceed as follows to set up the dish in Installer Action mode:
1. From the Dish Pointing page, click on the Installer Action link at the bottom
right hand corner of the page.
2. Enter the Satellite Number identifying the saved satellite location, as defined by
the dish motor manufacturer. You can enter a value in the range from 1 to 255.
3. Select the Installer Action. The following table describes the actions available:
5-14
Continued
Options
Continuous West
Movement
Continuous East
Movement
Stop Move
Goto Absolute
Position West
Goto Absolute
Position East
Goto Reference
D9865 Satellite Receiver Installation and Operation Guide
Description
Moves the dish west until it reaches its limit.
Ensure that the dish can move to its limit
without any obstructions.
Moves the dish east until it reaches its limit.
Ensure that the dish can move to its limit
without any obstructions.
Stops movement of the dish.
Moves the dish to the Absolute west position
set above.
Moves the dish to the Absolute east position
set above.
Moves the dish to a reference defined by the
dish motor manufacturer.
4035197 Rev C