Cisco D9865 Installation And Operation Manual page 56

Selection
NetId
Last Activated
Preset
Signal Lock
Signal Level
3. Press the green button (Save) to save and apply the settings to the receiver.
Selecting the Active Preset
To change the displayed preset to the Active preset or to select a different preset as
the active preset:
1. From the Tuning/Preset screen, press the yellow button (Preset).
2. Enter the preset in the Preset field that you want to activate. Enter the number
directly using the numeric keypad on the remote control or use the
buttons to change the number one digit at a time. Alternatively, press the red
button (keyboard) to enter the preset using an on-screen keyboard.
3. Select Activate (blue button) to choose the preset. This will activate the currently
displayed preset as the active preset.
You will be prompted to accept the new preset and warned that service
interruption will occur.
4. Select OK to proceed or EXIT to cancel the operation.
5. Press MENU to go to the previous menu.
Note: It will take up to 30 seconds for signal acquisition to occur. It can take longer
if the symbol rates are low.
Editing Network Presets
You can edit or pre-configure any one of 64 presets without affecting the operation
of the receiver.
To save or change a network preset:
1. Enter a Preset Number and a name directly to below the Preset Number. Follow
the editing rules for the keys when entering characters in the Name field.
2. Enter the appropriate settings as described in the preceding table. Ensure that
the LNB selection corresponds to the correct downlink frequency.
3. Press OK to save the preset.
4-22
Options
Enter Obtain the number from your service
number provider.
Indicates the number of the last activated
preset.
Indicates signal synchronization status.
Indicates the relative strength of the
received signal, in the range from 0 to 100.
D9865 Satellite Receiver Installation and Operation Guide
Description

4035197 Rev C