Cisco D9865 Installation And Operation Manual page 117

PV BER
LDPC BER
PER
C/N Margin
Signal Lock
Rolloff Mode
Rolloff Factor
LNB PS Status
Signal Level and Signal Quality
The Signal Level and Signal Quality of the incoming signal are displayed both
numerically and graphically using bar graphs.
The Signal Level is associated with the RF input signal level. The Signal Level
display is continuously updated to indicate the relative strength of the received RF
input signal. It is displayed in the range from 0 to 100.
The Signal Quality is associated with the Bit Error Rate (displayed in the range from
0 to 100). The Signal Quality is continuously updated to indicate the relative quality
of the received RF input signal.
4035197 Rev C
RF Status
Indicates the PV (Post-Viterbi) BER of the received
signal (DVB-S only).
Indicates the LDPC (Low-Density Parity-Check)
error rate of the selected input (DVB-S2 only).
Indicates the current PER (Packet Error Rate).
Indicates the current Carrier-to-Noise Margin of the
received signal, in dB. The Carrier-to-Noise margin
is the actual distance that C/N is from the noise
threshold.
Indicates the current signal lock status for the input.
Indicates the rolloff mode of the incoming signal.
The default is set to Auto.
Indicates the rolloff factor of the incoming signal.
Indicates the current LNB connection status (No
Load, Overloaded, OverTemp, Short Circuit,
Disabled, Normal, or N/A).
D9865 Satellite Receiver Installation and Operation Guide
Description
4-83