Cisco D9865 Installation And Operation Manual page 81

Setting up Advanced User Settings,
Changing the Lock Level
Receiver lock levels are password-protected. When an attempt is made to change
the lock level setting, a password prompt is displayed. After the correct password is
entered, you can change the lock level setting.
If the incorrect password is entered (any lock level setting), a message box appears
on-screen to confirm an invalid password entry, and access to the locked options
are denied.
Note: The default password is 1234.
For details on the four lock levels, see D9865 Satellite Receiver Lock Levels, on
page C-2.
Proceed as follows to change the lock level:
1. In the Administration menu, scroll to select Lock Level and press OK. The PIN
Entry screen appears.
2. Press OK to enter the current password using the numeric keypad on the
remote control and press OK. For security reasons, a default character is
substituted for each button pressed.

3. Use
then press OK. The default setting is 0. The Actual Lock Level parameter below
is updated to the new lock level.
Menu options change color (view-only) if disabled by the current lock level
setting.
Important: A virtual channel displayed for 20 seconds or more automatically
becomes the current (Last) channel. As Lock Level 3 disables most Lock Level 0
functions (including channel changes), perform this action before changing the
current Lock Level setting to 3.
4035197 Rev C
to select a valid lock level (lock levels are displayed from 0 to 3) and
D9865 Satellite Receiver Installation and Operation Guide
Continued
4-47