Cisco D9865 Installation And Operation Manual page 214

Warning
NIT timeout
CAT timeout
ECT timeout
Memory Usage Host Set
MPE near capacity
7-16
Message Message
Type
Set nit timed out
nit is lost
Clear nit fault cleared
Set cat timed out
cat is lost
Clear cat fault cleared
Set ect timed out
ect is lost
Reset ect fault cleared
Excessive (stack/
partition) memory
usage
Clear Normal (stack/
partition) memory
usage
Set Approaching current
capacity
D9865 Satellite Receiver Installation and Operation Guide
Cause/Remedy
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Cause: Uplink is not
sending or is sending
intermittently.
Remedy: Clear warning. If
the problem persists,
determine if uplink is
sending the current SI
information table. Disable
the warning if not using the
table.
Cause: Possible software
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: Unit is busy
processing or handling
other services.
Remedy: Reduce or stop
MPE service content.
Description
Network Information
Table was never
received.
No longer receiving
Network Information
Table.
Conditional Access
Table was never
received.
No longer receiving
Conditional Access
Table.
Event Control Table
was never received.
No longer receiving
Event Control Table.
SW exceeding
allowable memory
usage.
Decoder approaching
limit of safe CPU load
for MPE processing.
4035197 Rev C