Setting up LNB
To Set Up LNB Parameters
Proceed as follows to set up the LNB:
1. From the Preset/LNB Setup menu, press the yellow button (LNB) to set up the
LNB.
Note: You can configure up to 10 LNB presets.
2. The following table describes each of the options:
Selection
LNB Configuration
LNB Power
(For more
information, see LNB
Power Settings, on
page 4-25.)
4035197 Rev C
Options
1 to 10
18-H
13-V
Off
H-NIT
V-NIT
D9865 Satellite Receiver Installation and Operation Guide
Description
Number identifying the current preset LNB
configuration.
For H polarization.
For V polarization.
Use for external LNB power.
Note: LNB power must be on if DiSEqC is
required.
Initially applies the horizontal polarization
voltage, and then follows the polarization based
on the NIT.
Initially applies the vertical polarization voltage,
and then follows the polarization based on the
NIT.
4-23