Cisco D9865 Installation And Operation Manual page 63

Selection
DiSEqC
6. Press the blue button (Do Action) to save and apply the settings to the receiver
until the next reboot.
7. The following table describes the view-only information on the Dish Setup
screen:
4035197 Rev C
Options
Enable
Disable
Parameter
Modulation Indicates the modulation type for the received
signal.
LDPC BER Indicates the bit rate of the input stream of the
LDPC error correcting stage (DVB-S2 only).
Mode Indicates whether the current dish setup mode is
Installer or User. The mode can be changed by
pressing the yellow button.
NW Name Displays the network name.
PV BER Indicates the PV (Post-Viterbi) BER for the received
signal (DVB-S).
PER Indicates the current PER (Packet Error Rate).
DiSEqC Status Indicates whether the DiSEqC is enabled or
disabled.
Signal Quality Indicates the quality of the received signal,
associated with the Bit Error Rate, in the range
from 0 to 100.
Signal Level Displays the relative strength of the received RF
input signal. It is displayed in the range from 0 to
100.
D9865 Satellite Receiver Installation and Operation Guide
Description
Enables or disables Digital Satellite
Equipment Satellite Control.
Note: This must be enabled to control the
DiSEqC switch. LNB Power must be on to
use this setting. Refer to
www.eutelsat.com/satellites/4_5_5.html
more information.
Before you can adjust the satellite position
using the Adjust Dish Position screen or a
signal tone, ensure that the LNB Power and
DiSEqC (in the Tuning/Preset screen) are
enabled.
Description
http://
for
4-29