Cisco D9865 Installation And Operation Manual page 64

Adjusting the Satellite Position in Installer Mode
Note: To adjust the satellite position, the DiSEqC must be set to Enable.
1. On the Dish Setup screen, press the yellow button (Installer) to select Installer
mode.
2. Ensure the DiSEqC is set to Enable and then press the green button (Adj Dish).
3. Press the red or yellow button for fine west and east dish adjustment. Press the
green or blue button for coarse east and west dish adjustment.
Changing the Satellite Position in User Mode
To select a new satellite position on the Dish Setup menu:
1. Use the
2. Enter the pre-stored satellite number you want to use in the range from 1 to 255,
and press OK.
3. Press
4. Press
selected satellite position.
5. Press MENU to move to the previous menu, or EXIT to go to video.
4-30
Parameter
Signal Lock Indicates whether the receiver is synchronized with
the received RF signal.

buttons to move to Satellite Number and press OK.

to move down to User Action and press OK.

to choose Goto Satellite and press OK. The receiver is now tuned to the
D9865 Satellite Receiver Installation and Operation Guide
Description
4035197 Rev C