Cisco D9865 Installation And Operation Manual page 58

Selection
LO Freq1
LO Freq2
Crossover
LO Select
(Sets a 22 kHz tone
for Ku-band dual
LNB)
DiSEqC
DiSEqC Switch
Note: If you enter an invalid frequency setting or a setting that does not correspond
to the selection, a pop-up message such as "Input value out of range" is displayed.
3. Press the green button (Save) to save your settings.
4-24
Options
Enter
number
Enter
number
Enter
number
Off
On
Auto
Enable
Disable
Off
A to P
D9865 Satellite Receiver Installation and Operation Guide
Description
If C-band application, set to 5.15 GHz (default).
If Ku-band single LNB, enter LO Freq. and set
LO Freq 2 and Crossover to 0.0.
If Ku-band dual LNB, enter LO Freq 1, LO Freq
2 and Crossover.
Enter if Ku-band dual LNB application. LO Freq
2 > LO Freq 1.
Enter if Ku-Band dual LNB application. Used to
determine if LO Freq 1 or LO Freq 2 is used for
tuning.
Switches 22 kHz tone off.
Switches 22 kHz tone on.
Sets 22 kHz tone to automatic.
If Downlink Freq < Crossover use LO1. The 22
kHz tone is Off.
If Downlink Freq > Crossover use LO2. The 22
kHz tone is On.
Enables or disables Digital Satellite Equipment
Control. This must be enabled to control the
DiSEqC switch. LNB Power must be on to use
this setting. Refer to http://www.eutelsat.com/
satellites/4_5_5.html
Selects a port on the LNB switch (if used).
for more information.
4035197 Rev C