Cisco D9865 Installation And Operation Manual page 89

Configuring IP Setup,
Editing an IP Address
Proceed as follows to edit the Network IP Address:
1. From the IP Setup screen, press the yellow button (SetIPAddr).
2. The following table describes each of the options:
Selection
IP Address
Mask
Gateway Address
The Network Address, Prefix Mask, and Gateway Address should be changed
together, as a group. The following table shows the most commonly used
Subnet mask values to enter for a chosen IP address mask, which will depend on
the size of your network.
Note: Only Port 1 is available for this release.
4035197 Rev C
Continued
Options
12 digits in length
(###.###.###.###)/
8 to 32
12 digits in length
(###.###.###.###)
Mask
8
16
24
D9865 Satellite Receiver Installation and Operation Guide
Description
Sets the IP Address for its participation
in a Network environment.
Sets the Subnet Mask for its
participation in a Network
environment.
Sets the Network Gateway Address on
the Network, used to expose the
receiver to a WAN.
Subnet Mask
255.0.0.0
255.255.0.0
255.255.255.0
4-55