Cisco D9865 Installation And Operation Manual page 207

Alarm Message
Type
Flash Storage Set
Clear
LNB PS Set
Clear
DiSEqC HW Set
Fault
Clear
4035197 Rev C
Message
RECORD: init failed
RECORD
MANAGER: Record
contents check error,
erasing all
RECORD: sector
setup check error,
erasing sector
RECORD: init done
LNBPS: No Load
LNBPS: Over
Temperature
LNBPS: Over Loaded
LNBPS: Short Circuit
LNBPS: Normal
LNBPS: Disabled
LNBPS: Off
DiSEqC Hardware
Fault
D9865 Satellite Receiver Installation and Operation Guide
Cause/Remedy
Cause: Hardware
issue.
Remedy: Clear
alarms, reset the unit,
and notify customer
service if the problem
persists.
Cause: Hardware or
wiring issue.
Remedy: Clear
alarms, check LNB
and wiring, and
notify customer
service if the problem
persists.
Cause: Hardware
issue.
Remedy: Clear
alarms, check LNB
and wiring, and
notify customer
service if the problem
persists.
Ensure LNB power is
on (even if using
external LNB power)
and DiSEqC is
enabled.
Description Severity
Non-volatile Major
storage system
corrupted.
Possible loss of
configuration
NVS Corruption,
loss of
configuration
data
NVS Corruption,
loss of sector
data
LNB power Minor
overload
LNB power OK
Unable to send Minor
DiSEqC
commands to
external
equipment.
Automatically
cleared after a
few seconds.
7-9