Cisco D9865 Installation And Operation Manual page 135

4. Enable or disable the Digital Satellite Equipment Satellite Control (DiSEqC).
Note: This must be enabled to control the DiSEqC switch. LNB Power must be
on to use this setting. Refer to
for more information.
5. Set the Absolute Position of the satellite, in degrees. You can enter a value in the
range from 0.0 to 75.0 degrees.
6. The Tuner Performance section is the same as the Tuner Performance section in
the User Action mode. For more information, see above.
7. Click Apply.
4035197 Rev C
Goto Satellite
Store Satellite
Clear Limits
Store East Limits
Store West Limits
Calculate Position
None
D9865 Satellite Receiver Installation and Operation Guide
Moves the dish to the selected pre-stored
satellite position. Satellite positions are stored
in the dish motor, if supported, not in the
receiver.
Stores the current dish position as a Satellite
Number, if supported by the dish motor.
Clears the dish east and west limits stored in
the dish motor.
Stores the current position as the east limit in
the dish motor.
Stores the current position as the west limit in
the dish motor.
Updates the position of the dish according to
the current position. For more information,
refer to the dish manual provided by the dish
manufacturer.
No action is performed.
http://www.eutelsat.com/satellites/4_5_5.html
5-15