Cisco D9865 Installation And Operation Manual page 215

Warning
Ethernet MAC
Failure
Ethernet PHY
Failure
Ethernet Port 1 or
Ethernet Port 2
FW: Resource Use
PRI
Backup Operation
State
Backup Failure
Reason
Restore Failure
Reason
4035197 Rev C
Message Message
Type
Set MAC configuration
failed
Clear Failure cleared
Set Marvel switch
configuration failed
Clear PHY failure
monitoring reset
Set ETH Port 1 or 2 Link
Down
Reset ETH Port 1 or 2 Link
Up
Set Memory or List Near
Full
Clear
Set Backup Active
Clear Backup Complete
Set Internal Error
FTP Failed
Clear Auto reset after
timeout
Set Not Accepted
Bad Content
FTP Failed
Clear Auto reset after
timeout
D9865 Satellite Receiver Installation and Operation Guide
Cause/Remedy
Cause: Possible hardware
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if problem
persists.
Cause: Possible hardware
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: Ethernet port 1 or 2
is not connected.
Remedy: Connect Ethernet
port 1 or 2.
Cause: Possible software
issue.
Remedy: Clear warnings,
reset the unit, and notify
customer service if the
problem persists.
Cause: Possible software
issue.
Remedy: Check FTP
configuration, reset unit,
and notify customer service
if problem persists.
Cause: Possible software
issue.
Remedy: Check FTP
configuration, reset unit,
and notify customer service
if problem persists.
Description
Errors like Fatal Bus
Error.
Related to MII
register read/write
failures.
Ethernet port 1 or 2 is
not connected.
Software exceeding
allowable usage of
internal constructs.
Backup operation
started.
Backup operation
complete.
Software error
occurred.
FTP failed.
Warning
automatically clears
in 30 seconds.
Software error
occurred.
FTP failed.
Warning
automatically clears
in 30 seconds.
7-17