Setting Up Lnb Presets - Cisco D9865 Installation And Operation Manual

Setting up LNB Presets

To Set Up the LNB Presets
Proceed as follows to set up the Dish Presets:
1. From the user interface of the D9865, click Input > Satellite, expand Tuning
Presets and then click LNB Presets. The LNB Presets page is displayed.
2. Select the LNB Configuration number, identifying the current present LNB
configuration. You can select a number in the range from 1 to 10.
3. The LNB Power setting determines if power is provided via the input to an
external LNB connection.
You can set the LNB Power to Off, 18-H, 13-V, H-NIT, or V-NIT. The default is
18-H. If LNB Power is set to V-NIT or H-NIT, the signal polarization is
automatically read from the NIT. Power will not be applied to the LNB if LNB
Power is set to Off.
Note: LNB power must be on if DiSEqC is required.
For more information, see LNB Power Settings, on page 4-25.
4. The LO Select is only applicable for dual-band LNB applications. It sets whether
or not the 22 KHz tone is available. The selections are On, Off, or Auto (if
downlink frequency is greater/less than the crossover frequency, the 22 KHz
tone is automatically set to on/off). The default is Off.
4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 5-23