Cisco D9865 Installation And Operation Manual page 144

Setting up Dish Presets,
5. Set the Local Oscillator Frequency #1 (LO Freq 1), which sets the satellite
antenna LNB local oscillator #1 frequency. For C-Band application, set to 5.15
GHz. For Ku-band single LNB, enter LO Freq and set LO Freq 2 and Crossover
Frequency to 0.0. For Ku-band dual LNB, enter LO Freq 1, LO Freq 2 and
Crossover Frequency. The default is 10.75 GHz.
6. Set the Local Oscillator Frequency #2 (LO Freq 2), which sets the satellite
antenna LNB local oscillator #2 frequency. This option is only used in dual-band
LNB applications. LO Freq 2 must be greater than LO Freq 1. The default is 0.0
GHz.
7. Enter the Crossover. This is an internal threshold frequency used for selecting
the LO1 or LO2 frequency, depending on the current downlink frequency
settings. This option is only used in dual-band LNB applications. The default is
0.0 GHz.
8. Enable or disable the Digital Satellite Equipment Satellite Control (DiSEqC).
Note: This must be enabled to control the DiSEqC switch. LNB Power must be
on to use this setting. Refer to
for more information.
9. In the DiSEqC Switch drop-down list, select a port on the LNB switch, if used
(Off, A to P).
10. Click Apply to Preset.
5-24
Continued
D9865 Satellite Receiver Installation and Operation Guide
http://www.eutelsat.com/satellites/4_5_5.html
4035197 Rev C