Changing Hardware Configuration; How To Enable Lom; Updating Fru Information - Hitachi CB 520H B1 Service Manual

Changing hardware configuration.

1 Remove server blade from chassis. See
.
blade on page
2 Open the top cover. See
.
5-38" section.
3 Remove LOM pass through connector. See
.
connector in half-wide server blade on page
You need to remove both LOM pass through connector slot #1 and #3 at
the same time.
Keep LOM pass through connectors for future use.
4 Install mezzanine cards on server blade if you need. See
.
mezzanine card on page
Supported combination of mezzanine cards is same as CB 540A A1/B1.
5 Close the top cover.
.
6 Insert server blade to the chassis. See
.
on page

How to enable LOM.

Updating FRU information.

1 [For CB 520H B1/B2/B3/B4, CB 540A B1, and Non-SMP CB 520X
.
B1/B2/B3]
10-8
5-6" section.
5-7" section.
Change LOM configuration
Hitachi Compute Blade 500 Series System Service Manual
"Removing a full-wide server
"Opening a top cover, Server blade on page
"Replacing a LOM pass through
5-53" section.
5-52" section.
"Installing a full-wide server blade
"Installing a