Product Version; Release Notes; Document Organization - Hitachi CB 520H B1 Service Manual

• The reader is familiar with the location where the Compute Blade will be
installed, including knowledge of physical characteristics, power systems
and specifications, and environmental specifications.

Product Version

This document revision applies to CB 520X B3.

Release notes

Read the release notes before installing and using this product. They may
contain requirements or restrictions that are not fully described in this
document or updates or corrections to this document.

Document Organization

The table below provides an overview of the contents and organization of this
document. Click the chapter title in the left column to go to that chapter. The
first page of each chapter provides links to the sections in that chapter.
Chapter 1, Introduction
Chapter 2, Replaceable parts
Chapter 3, Basic knowledge for
replacement
Chapter 4, Common process for
replacement
Chapter 5, Replacing parts
Chapter 6, Identifying RAID
rebuild status
Chapter 7, Configuring Emulex
mezzanine card
Chapter 8, Diagnosing server
blade
Chapter 9, Updating firmware
Chapter 10, Change LOM
configuration
Chapter 11, Troubleshooting
Chapter
Hitachi Compute Blade 500 Series System Service Manual
Description
Describes the overview of user maintenance and
troubleshooting tasks for the Hitachi Compute Blade
500 Series.
Describes the replaceable parts for Hitachi Compute
Blade 500 Series.
Describes how to verify a failed part and how to
order a failed part.
Describes the common processes before replacing
part.
Describes how to remove and install parts on the
Hitachi Compute Blade 500 Series.
Describes how to confirm the rebuild progress after
HDD replacement.
Describes how to configure Emulex mezzanine card
after replacement.
Describes how to diagnosing the server blade.
Describes how to update firmware.
Describes how to change LOM configuration.
Describes how to troubleshoot the Hitachi Compute
Blade 500 Series.
Preface
xxiii