Updating Firmware On Management Module - Hitachi CB 520H B1 Service Manual

Note: Do not power off the server blade during updating the firmware.

Updating firmware on management module

Tip: Before performing the following procedures, you must download the
updated firmware file from Hitachi Data System support portal to the console
PC.
Notice:
Restriction: Firmware on Management module before ver. A0145 does
not support disabling LOM on CB 540A A1/B1. If you want to backdate
ver. A0145 or earlier on CB 540A B1, enable LOM according to change
LOM configuration procedure. See
configuration".
1 Select Resources tab and select Modules > Management Modules.
.
2 Click Action and then select Update Firmware.
.
3 The update dialog box is displayed. Check Update that you should update
.
the data.
4 Click Browse and select the new firmware file.
.
5 Click Confirm.
.
Figure 9-2 Start the updated firmware
Updating firmware
Hitachi Compute Blade 500 Series System Service Manual
"Chapter 10, Change LOM
9-3