Installing A Sd Card Enablement Kit; Replacing A Mezzanine Card In The Storage Expansion Blade; Removing A Mezzanine Card - Hitachi CB 520H B1 Service Manual

Installing a SD card enablement kit

1 Put on an anti-static wrist strap.
.
2 Reverse the removal procedure.
.

Replacing a mezzanine card in the storage expansion blade

This procedure describes how to remove a mezzanine card from the storage
expansion blade.

Removing a mezzanine card

1 Put on an anti-static wrist strap.
.
2 Record the parameters in the case of replacing Emulex HBA card.
.
See
3 Remove the target storage expansion blade.
.
See
4 Open the top cover of the server blade. See
.
blade on page 5-38
5 Open the lock tabs, as shown below.
.
6 Grab the mezzanine card shown as arrows A and B, then lift up the
.
mezzanine card and remove it from the storage expansion blade
assembly.
5-62
Figure 5-75 Removing the SD card enablement kit
Configuration procedure for Emulex HBA card on page 7-2
Removing a storage expansion blade on page 5-11
section.
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
Opening a top cover, Server