Removing A Sas Hdd Kit; Installing A Sas Hdd Kit - Hitachi CB 520H B1 Service Manual

Replacing a SAS HDD kit in CB 520X B1/B2/B3

Removing a SAS HDD kit

1 Put on an anti-static wrist strap.
.
2 Remove the target server blade.
.
See
3 Open the top cover of the server blade. See
.
blade on page 5-38
4 Remove a disk drive.
.
See
5 Pull up the connector side of SAS HDD kit while holding the near portion
.
of the connector of enclosure by both hands.
6 Pull up the front panel side of SAS HDD kit, and then release the pins
.
from the hinge brackets.

Installing a SAS HDD kit

1 Put on an anti-static wrist strap.
.
2 Slide in the pins of SAS HDD kit on the front side into the hinge brackets
.
on the front side of the enclosure.
3 Press the portion indicated PRESS HERE on the SAS HDD kit.
.
Removing a full-wide server blade on page 5-6
section.
Removing a disk drive on page 5-36
Figure 5-128 Removing SAS HDD kit
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
Opening a top cover, Server
section.
5-99