10Gb Lan Pass Through Module/10Gb Lan Pass Through Module2 - Hitachi CB 520H B1 Service Manual

No.
4 Uplink port status
LED1
5 Uplink port status
LED2
6 Uplink ports
1- 8

10Gb LAN pass through module/10Gb LAN pass through module2

Figure 1-48 10Gb LAN pass through module/10Gb LAN pass through
Table 1-40 LEDs and connectors on 10Gb LAN pass through module/10Gb
No.
1 Power LED (PWR)
2 Status1 LED
(ST1)
Name State
Amber-On
Amber-Blink Blink slowly: LAN interface disabled.
Off
Green-On
Green-Blink Blink irregularly: A link active.
Off
-
LAN pass through module2
Name State
Green-On
Off
Green-On
Green-Blink
Amber-On
Amber-Blink
Introduction
Hitachi Compute Blade 500 Series System Service Manual
Description
A signal or communication received, but not
on line.
Blink rapidly: LAN interface fail.
No signal and communication are received.
LAN interfaces online.
Blink slowly: LAN interfaces online, but
segmented.
Blink rapidly: Diagnosing internal loop-back.
No signal and communication are received.
By default these ports do not have
transceivers installed. The type of transceiver
varies according to usage.
module2
Description
Power-On and normal operation.
Abnormal power state (Power failure or no
power is supplied).
Normal operation.
During power-on diagnosis or software
activation.
A serious failure detected. (Flashing during
LED test of power-on diagnosis, it is not a
failure.)
The warning detected. (The switch
operates, but the function is reconfigured
1-37