Replacing A Half-Wide Server Blade For Storage Expansion Blade; Removing A Server Blade With A Storage Expansion Blade - Hitachi CB 520H B1 Service Manual

13 Perform the smart configure process.
.
See
14 Verify that the replacement was successful through the MAR log.
.
See
15 Turn off LID LED for identifying the target blade.
.
See
Notice:
Do not install the server blade without the top cover. The server chassis
has a mechanical security to prevent installation without the top cover.
Bypassing this security feature can cause serious damage of server
chassis or server blade.
Replacing a half-wide server blade for storage expansion
blade
The hot-swappable feature of the Hitachi Compute Blade 500 series system
allows the replacement of the server blade for storage expansion blade with
the server chassis power on. This procedure describes how to replace a
server blade for storage expansion blade when the server chassis power is
on.

Removing a server blade with a storage expansion blade

1 Removing a server blade with a storage expansion blade.
.
See
2 Opening a top cover of server blade and storage expansion blade.
.
See
cover, Storage expansion blade on page 5-39
3 Loosen two screws on the bracket of pass through mezzanine component
.
in the storage expansion blade, and then remove it.
4 Open the lock tabs, as shown below.
.
Smart configure procedure for server blade on page 4-52
Alert information identification procedure on page 4-5
Identify LED (LID) on/off procedure on page 4-7
Removing a storage expansion blade on page 5-11
Opening a top cover, Server blade on page 5-38
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
section.
section.
and Opening a top
section.
5-17