Replacing An Sfp+ Module; Removing An Sfp+ Module - Hitachi CB 520H B1 Service Manual

Replacing an SFP+ module

This procedure describes how to replace an SFP+ module or SFP+ copper
cable.
CAUTION:
The device contains a laser that is classified as a Class 1 Laser Product.
Do not look directly at the laser beam.

Removing an SFP+ module

SFP+ module for LAN switch/8Gb FC switch/DCB switch/LAN pass trough
1 Put on an anti-static wrist strap.
.
2 Connect Web console. See
.
section.
3 Turn on LID LED for identifying the target module.
.
See
4 Turn on the maintenance mode from web console.
.
See
5 Remove a cable from the failed FC port.
.
6 Release the lever shown as below.
.
7 Hold the released lever and pull it toward you.
.
SFP+ module for 16Gb FC switch
1 Put on an anti-static wrist strap.
.
2 Connect Web console. See
.
section.
3 Turn on LID LED for identifying the target module.
.
See
4 Turn on the maintenance mode from web console.
.
5-114
Identify LED (LID) on/off procedure on page 4-7
Maintenance mode on/off procedure on page 4-10
Figure 5-144 Removing an SFP+ module
Identify LED (LID) on/off procedure on page 4-7
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Web console login procedure on page 4-3
Web console login procedure on page 4-3
section.
section.
section.