Replacing A Lom Pass Through Connector In Half-Wide Server Blade - Hitachi CB 520H B1 Service Manual

Notice:
You can install the mezzanine card at the slot number 1 or 3 on CB 540A
B1 after removing LOM pass through connector and updating the FRU.
See
Replacing a LOM pass through connector in half-wide server
blade
This procedure describes how to remove a LOM pass through connector from
the server blade.
through connectors.
Do not remove screws except for that hold the LOM pass through
connectors. Work performed by unqualified persons can lead to an electric
shock, fire, or burns. Especially it is hazardous if you touch areas inside
the high-voltage power module.
Note: Use the Phillips screwdriver satisfying the following conditions.
Screw size : 2M
Shaft diameter : 4Φ
Figure 5-68 Installing the mezzanine card
"Chapter 10, Change LOM
Do not remove screws except for that hold the LOM pass
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
configuration".
5-53