Replacing A Disk Drive - Hitachi CB 520H B1 Service Manual

9 Push in the connection board into the server blade straight downward by
.
pushing the portion indicated Push, and then close the two latches.
10 Push in the connector into the PCI expansion blade straight downward by
.
pushing the portion indicated Push, and then close the latch.
11 Close the top cover of server blade. See
.
on page 5-39
12 Close the top cover of PCI expansion blade. See
.
expansion blade on page 5-41
13 Install the PCI expansion blade. See
.
server chassis on page 5-16

Replacing a disk drive

This procedure describes how to replace the disk drive in a server blade or a
storage expansion blade. The disk drive is hot-swappable component and
allows disk drive replacement with the server blade power on.
Note:
• Back up all user data before replacing a disk drive. When the RAID group
and logical unit are deleted or formatted, the user data will be lost.
• Do not remove the failed disk drive if the LEDs of itself or another disk
drive in the same server blade or storage expansion blade indicate the
following conditions.
Figure 5-42 Installing connection kit F/H
section.
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Closing a top cover, Server blade
Closing a top cover, PCI
section.
Installing a PCI expansion blade into
section.
5-35