Updating Firmware On Switch Module - Hitachi CB 520H B1 Service Manual

Note: If the only dictionary file and parameter file are updated, the
management module does not reboot. Only when the management module
firmware is updated, the management module will reboot.
Note: Do not power off the management module and disconnect the LAN
cable during updating the firmware.

Updating firmware on switch module

Tip: Before performing the following procedures, you must download the
updated firmware file from Hitachi Data System support portal to the console
PC.
1Gb LAN switch module or 1/10Gb LAN switch module
1 Click Start > Programs > Accessories > Communications >
.
HyperTerminal to boot up terminal software.
Figure 9-4 Start the updated firmware
Updating firmware
Hitachi Compute Blade 500 Series System Service Manual
9-5