Smart Configure Procedure For Server Blade - Hitachi CB 520H B1 Service Manual

Tip: If you set up NTP or time zone, refer to the user's guide of the FC switch
module that you should set up.

Smart configure procedure for server blade

When the server blade was replaced, you need to perform the smart
configure process. The smart configure process is important for the server
blade replacement because starting the configuration data backup. This
section describes how to perform the smart configure process.
Smart configure for CB 520A A1, CB 520H A1/B1/B2/B3/B4, CB
540A A1/B1, and Non-SMP CB 520X B1/B2/B3
1 Select Resources tab and select Modules > All Modules > Server
.
blades > target server blade.
2 Select Condition tab.
.
3 Click Server Blade Action and then select Run Smart configure.
.
4 The confirmation dialog box appears. Click OK. Smart configure process
.
will be started.
4-52
Common process for replacement
Hitachi Compute Blade 500 Series System Service Manual