8Gb / 16Gb Fc Switch Module - Hitachi CB 520H B1 Service Manual

17 Enter y , and then press Enter key.
.
18 The following message is displayed. Confirm "Update is finished
.
successfully." message.
Note: Do not power off the switch module and disconnect the LAN cable
during updating the firmware.

8Gb / 16Gb FC switch module

1 Click Start > Programs > Accessories > Communications >
.
HyperTerminal to boot up terminal software.
2 The Connection Description window is displayed. Enter telnet1, and
.
then click OK.
3 Select TCP/IP (Winsock), enter < IP address > in the Host address,
.
and then click OK.
< IP address >:IP address for the target switch module. See
address setup procedure for switch module on page 4-18
4 The login prompt is displayed in the terminal.
.
9-8
Updating firmware
Hitachi Compute Blade 500 Series System Service Manual
Internal IP
section.