See
section.
4
Open the top cover of the PCI expansion blade.
.
See
5
Open the two lock levers, and then pull up the mezzanine card and
.
remove it from the PCI expansion blade.
Figure 5-91 Removing the mezzanine card- PCI expansion blade
Installing a mezzanine card
1
Put on an anti-static wrist strap.
.
2
If the connector cover is installed in the mezzanine slot #4, remove it
.
from the slot first.
3
Align the three alignment holes of mezzanine card with the guide pins, as
.
shown below.
4
Reverse the removal procedure.
.
5-74
Removing a PCI expansion blade from server chassis on page 5-15
Opening a top cover, PCI expansion blade on page 5-40
Figure 5-92 Removing the connector cover
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.