Installing A Connection Kit F/H - Hitachi CB 520H B1 Service Manual

Installing a connection kit F/H

1 Put on an anti-static wrist strap.
.
2 If the connector cover is installed in the mezzanine slot #2, remove it
.
from the slot.
3 Align the connector and guide holes of the connection board of the
.
connection kit F/H with the male connector and guide pins on the main
board of the server blade, respectively.
4 Push in the connection board into the server blade straight downward by
.
pushing the portion indicated Push, and then close the two latches.
5 Push in the connector into the PCI expansion blade straight downward by
.
pushing the portion indicated Push, and then close the latch.
5-76
Figure 5-94 Removing the connection kit F/H
Figure 5-95 Removing the connector cover
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual