Replacing A Mezzanine Card In Full-Wide Server Blade; Removing A Mezzanine Card - Hitachi CB 520H B1 Service Manual

Figure 5-65 Restriction for installing to the server blade with LOM

Replacing a mezzanine card in full-wide server blade

This procedure describes how to remove a mezzanine card from the server
blade.

Removing a mezzanine card

1 Put on an anti-static wrist strap.
.
2 Record the parameters in the case of replacing Emulex HBA card.
.
See
3 Remove the target server blade.
.
See
4 Open the top cover of the server blade. See
.
blade on page 5-38
5 Open the lock tabs, as shown below.
.
6 Grab the mezzanine card shown as arrows A and B, then lift up the
.
mezzanine card and remove it from the server blade assembly.
Configuration procedure for Emulex HBA card on page 7-2
Removing a full-wide server blade on page 5-6
section.
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
section.
Opening a top cover, Server
5-51