Installing A Mezzanine Card - Hitachi CB 520H B1 Service Manual

Figure 5-76 Removing the mezzanine card- storage expansion blade

Installing a mezzanine card

1 Put on an anti-static wrist strap.
.
2 If the connector cover is installed in the slot where you want to install the
.
spare mezzanine card, remove the cover from the slot first.
3 Align the three alignment holes of mezzanine card with the guide pins, as
.
shown below.
4 Reverse the removal procedure.
.
5 Configure the parameters in the case of replacing Emulex HBA card.
.
See
6 Perform
.
Figure 5-77 Removing the connector cover
Configuration procedure for Emulex HBA card on page 7-2
Installing a storage expansion blade on page 5-12
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
procedure.
5-63