Changing Lom Pass Through Connector Configuration - Hitachi CB 520H B1 Service Manual

9 Click Hardware tab and confirm whether LOM status is correct.
.

Changing LOM pass through connector configuration.

Note: Change hardware configuration after registering LOM license key, if
required.
1 Remove server blade from chassis. See
.
blade on page
2 Open the top cover. See
.
on page
3 Remove or install LOM pass through connector. See
.
pass through connector in half-wide server blade on page
Keep LOM pass through connectors for future use.
5-6" section.
5-38" section.
Change LOM configuration
Hitachi Compute Blade 500 Series System Service Manual
"Removing a full-wide server
"Preparing for replacing an internal component
"Replacing a LOM
5-53" section.
10-13