Removing A Power Supply Module; Installing A Power Supply Module - Hitachi CB 520H B1 Service Manual

Removing a power supply module

1 Put on an anti-static wrist strap.
.
2 Connect the web console. See
.
section.
3 Set on the maintenance mode from web console.
.
See
4 Open the cable retainer to release the power cord, as shown below.
.
5 Remove the power cord from the failed power supply.
.
6 Pull the lock tab while unlocking it and then remove the failed power
.
supply.

Installing a power supply module

1 Put on an anti-static wrist strap.
.
5-122
Maintenance mode on/off procedure on page 4-10
Figure 5-153 Removing the power cord
Figure 5-154 Removing the power supply module
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Web console login procedure on page 4-3
section.