Table of Contents
Advertisement
Hardware options installation
Introduction
Install any hardware options before initializing the server. If multiple options are being installed, read the
installation instructions for all the hardware options to identify similar steps and streamline the installation
process.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before beginning
any installation procedure. Improper grounding can cause electrostatic discharge.
Controllers
Installing a type-p storage controller
Prerequisites
Before installing this option, be sure you that have the following:
•
The components included with the hardware option kit
•
T-10 Torx screwdriver
Procedure
1.
Observe the following alerts:
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal
system components to cool before touching them.
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause electrostatic discharge.
2.
Back up all server data.
3.
Power down the server.
4.
Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
Hardware options installation
40
Advertisement
Table of Contents
